macrO Safe Carbide Milling Cutter 189NC012 (without abrasive)

Brand: macrO
Manufacturer: Germany

The carbide nail drillbit is used for the correction of acrylic and gel nails: rough cutting, cutting under the nails, correcting the shape and length. It can also be used for cutting off exfoliation, removing gel, gel polish, and pedicure.
The macrO drill bits are subject to thermal and liquid sterilization.

Carbide nail drill bits care:

It is safer to store the drill bits in a special lockable case. Disinfect, clean and sterilize the drill bit after each use and each client.

Immediately after use, place the handpiece in a disinfectant solution; do not rinse it under water. After you have disinfected the handpiece, only then should you rinse it under running cold water.

Next, clean the handpiece. For ceramic handpieces, special brass brushes are used, which can also successfully clean carbide handpieces.

After that, we proceed to sterilization. Either thermal (glasperlene sterilizer, dry heat oven, autoclave) or chemical (concentrates).

Cleaning of any nozzles is quick and efficient in an ultrasonic sink. It uses the principle of cavitation and your instruments are cleaned in parallel with disinfection.

The abrasive of the drill bits is distinguished by a colored notch:

• green - hard
• blue - medium hardness
• red - softer